• AutoShop 101
  • Automotive Schools
  • Body
  • Brakes
  • Communication
  • Cooling
  • Drivetrain
  • Electrical
  • Engine
  • Exhaust
  • Fuel
  • HVAC
  • Oil & Lubrication
  • Suspension
  • Wheels and Tires
• Car Care
  • Clean Your Paint
  • Engine Compartment
  • Paint Chips
  • Protect Your Paint
  • Tires Rubber and Vinyl
  • Washing Your Car
  • Wheels
• Car Shopping
  • Buying
  • Finance
  • Research Sites
  • Selling
  • Warranty
• Car Insurance
• Car Blog
• Motorcycles

• Ask The Mechanic
• - Repair Manuals
• - Newsletter

Oil Change

Maintaining your motorcycle is critical to it's long lasting performance and safety on the road. Just as with a car, the oil is the lifeblood for your motorcycle. If you do anything yourself, the oil change is something that can be done even by the novice person. It is quite simple and inexpensive if you have the right tools and patience.

Consult your owners and maintenance manual for your motorcycle, but typically your oil should be changed every 3-5k miles, or at a minimum of every 6 months.

Before you rush to do this oil change, take your motorcycle for about a 10 minute ride. This will enable the oil to heat up and flow out much more easily. Once you're back from your quick ride, set up an area that you can move around and that is clean. If you have a center or rear stand for you bike, use it as it helps keep the bike in an upright position. If not, use the side stand for now and I'll tell you what to do later.

Tools and items needed:
- Owner's or service manual
- Oil
- Oil filter
- Drain Plug Washer (you'll replace the old one)
- Open end wrench (or ratchet)
- Drain pan
- Tool to remove the filter (leather or rubber belt will do)
- Shop Rags
- Funnel
- Torque wrench (recommended)

Now that you have your clean area and all the tools and items around you, go ahead and place the drain pan under the drain plug/bolt on your bike. Use the correct tool to remove the bolt, as you do not want to strip it. Once you pull it out, the oil will drain fast so make sure you have your oil pan set right under the drain.

While the oil is draining, you can go onto the oil filter. Use your manual to locate the oil filter. Carefully unscrew the oil filter. You can either use a filter wrench to unscrew it, or you can even use an old leather belt or even a rubber belt. As you do this, just be careful not to dent the filter. When pulling out the filter, you may have a little oil still left in there that could splash out. Use your clean shop rags and wipe everything down.

By now the oil should have completely drained from the plug and into the pan. Go ahead and remove the old and replace with a new drain plug washer.

Clean off the drain bolt and put it back in. Don't overtighten the drain bolt. Check your owners manual for how much torque you should use. If you're not checking torque to spec, simply install it snug and do not overtighten.

Back to the filter. Add some fresh oil to the new filter (about a 1/4 full) and swirl it around to make contact with the filter. Then, take your finger and spread oil around the rubber seal to wet it with oil (helps create good contact with the engine). Clean off your motorcycle around the area where the filter is to ensure all parts are clean. Now go ahead and install your new filter. Carefully screw in the new filter, but again be careful not to overtighten it. Simply use your hands and no tools required.

Slide the oil pan out of your way so as not to spill it, and grab your fresh oil and funnel. Consult your owners manual to figure out what your oil capacity (# of quarts) is for your motorcycle. You do not want to overfill your oil on your bike. So, fill it up to where you're between 'full' and 'add'. You'll need to stand your motorcycle upright when checking your oil as you do not want it to be leaned over (it will change your readings of the oil).

Clean your bike off and make sure all bolts and caps have been put back on. Take a 5 minute ride around the block to make sure everything is fine and that there are no leaks. Check the oil level again to ensure the right capacity, and you should be good to go.

Pat yourself on the back that you've now prolonged the life of your motorcycle and go enjoy your next ride!!

If you want to see a video of an oil change, click here on Youtube. This is a video of just a sport bike, but the concept is the same for all motorcycles.

Used motorcycle oil - take your oil from the pan and try to pour it back into the original oil containers, or an empty laundry detergent bottle. Most likely your town dump or municipal building will take your used oil. Just be environmentally safe, and do not dump the oil. It's dangerous, and illegal.

Click here to shop for parts and supplies for your motorcycle at Bikebandit.com.

Click here to shop for parts and supplies for your motorcycle at Cruisercustomizing.com.

 

Share This Page With Your Friends